← Portfolio

GD-RP-001: Replacement Dispenser Nozzle Hook

Real-world repair · Black ASA · Installed and in daily use.

3D printed black ASA replacement hook holding a fluid dispenser nozzle in its holder
The printed hook installed on the nozzle and hooked into the holder.

The problem

The plastic hook that holds a fluid dispenser’s nozzle in its holder snapped, so the nozzle had nowhere to hang.

Measure and model

Zack measured the broken original and rebuilt it in Onshape. A ring with a Ø29.5 mm bore slips over the nozzle body, and two small retention nubs keep it from sliding. A sloped flange seats the ring. A small key rib, copied from the original, lines up with a slot in the trigger so the hook stays in line. An angled T-section arm reaches over and hooks into the dispenser’s holder, and the T-section keeps it stiff without adding bulk.

Print

Printed in black ASA on his K2 Plus. ASA is tough and holds up to heat and UV. The part weighs about 11.5 g.

The result

It’s installed and in daily use, holding the nozzle just like the original did.

CAD render of the black replacement dispenser nozzle hook
The replacement hook, modeled in Onshape (CAD render).

The drawing

Rev B print, GD-RP-001. Select the sheet to open it full size, or download the PDF.

Drawing GD-RP-001 Rev B, Replacement Dispenser Nozzle Hook
GD-RP-001 Rev B: replacement dispenser nozzle hook, with a Ø29.5 mm bore, key rib and T-section arm.
Status: Installed and in daily use

Got a broken part nobody sells anymore? Send a photo, and we'll model it and print it.

Request a quote