← Portfolio

GDF-P07: 4-Gang Rocker Switch Panel (practice project)

Four Contura-style switches for a light bar, pump and compressor, mounted in a clean two-part panel that hides the wiring and goes together without tools. (Practice project: an original drawing set in the Gearhed Design & Fabrication title block, not a client job.)

Print coming soon. Estimated 4–5 hours on the K2 Plus.

CAD render of a 3D printable 4-gang rocker switch panel with bezel and housing
The bezel snapped onto the drafted housing, with the harness grommet on the side (CAD render, practice project).

The design

  • A front bezel holds the switches in a datum-located cutout pattern.
  • A drafted housing (2° outside draft, built from a neutral plane) hides the wiring behind it.
  • The parts snap together on four toleranced cantilever hooks, with no screws.
  • Two M4 brass heat-set inserts handle mounting, and the harness exits through a Ø16 grommet.
  • Both parts are planned in ASA for heat and UV resistance.

The process

Zack modeled it in Onshape from 2D reference prints. Both parts and the assembly matched the reference within 0.13%, with zero interference. Along the way he caught a radius-vs-diameter callout error in the source prints.

Skills shown

Snap-fit tolerancing, datum-located cutout patterns, draft with a neutral plane, heat-set insert holes, broken-out section views, fitting a purchased part, and checking drawings.

The drawing sheets

Original practice drawing package (GDF-P07). Select a sheet to open it full size, or download all three sheets as a PDF.

Drawing sheet 07-1 Switch bezel (4-gang)
07-1 Switch bezel (4-gang)
Drawing sheet 07-2 Switch housing
07-2 Switch housing
Drawing sheet 07 Assembly: 4-gang switch panel
07 Assembly: 4-gang switch panel
Status: Print coming soon. Estimated 4–5 hours on the K2 Plus.

Have a panel or bracket in mind?

Request a quote